The method of using the fully automatic pipe bending machine is as follows:
Preparation: Place the steel pipe to be processed at the machine feed port, adjust the clamping force of the clamp to ensure that the steel pipe does not slide or move.
Set parameters: Set the bending angle, radius and length and other parameters according to the processing requirements to meet the requirements.
Start the machine: After confirming that all parameters are set correctly, press the start button and the machine will start working.
Monitor the processing process: Observe the processing process at any time to ensure that the machine operates normally and the processing effect meets the requirements.
Check the finished product: After the processing is completed, take out the finished product for inspection. If there is any abnormality, it is necessary to readjust the parameters and process it again.
Turn off the machine: After the processing is completed, turn off the fully automatic pipe bending machine, clean the machine, and pay attention to safe operation.
In short, when using the fully automatic pipe bending machine, you need to read the instructions carefully, master the correct operation method, and strictly abide by the safety operating procedures.